I had some problems with Adaptec SA. November 18th, 7. Well, you really have to see it. All times are GMT Inform me as to what the difference would be if i mounted them all to the same mount point. Command Line Interface User’s Guide. You can find help regarding which commands are available from the command line utility by entering the ARCCONF command without additional commands or parameters.

Uploader: Kegore
Date Added: 10 June 2014
File Size: 13.29 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 3695
Price: Free* [*Free Regsitration Required]

Are you new to LinuxQuestions. Some tools and drivers are available from the vendor.

LinuxRaidForAdmins – Debian Wiki

Latest version seems to be provided as afaapps Attached scsi generic sg5 type 0 [ 7. Configure your server individually at www.

With the -vv option you might see if a kernel module has been loaded to support it. There are Debian packages of both tools available from http: Debian-Installer Is the hardware supported by the Debian-Installer?

Note that registered members see fewer linhx, and ContentLink is completely disabled once you log in. This page has been accessed 48, times. Hardware using this driver: Areca arcix raid card setup No specific reason to be honest, and no i am not. How can I find that out which device is associated with the raid array?

  BROADCOM NETXTREME BCM5722 GIGABIT ETHERNET DRIVER

In a raid 10 there are basically 10 raid 1s inside of it so if 1 drive dies in one of the raid 1s its okay I dont think this is the correct raid to make one big drive with the same fault tolerances as what 10 sets of raid 1 would do for me.

In the worst case, losing 2 drives from the same mirror would cause a failure. Luckily, if you set up a spare or two on your array, there are no parity calculations that need to be done, so a spare can be added very quickly, and greatly reducing the window for this possibility.

See if this is loaded with Code:. Yes hpsa Yes Yes Yes? Your feedback is welcome Printable version. You can check the status and other things using the sas2ircu utiliity.

I thought if you had 3 drives, it just made the 3rd a drive that would just take over if one of the other failed. Click Here to receive this Complete Guide absolutely free.

If what you say exists i will be redoing all my raids. All Linux-based systems that use the Linhx driver in versions lower than 1. Areca arcix raid card setup No, I didn’t say it would have the same fault tolerance as 10 RAID1 arrays, but it’s more than adequate. The ‘sg’ module must be loaded for it to work, the cli program segfaults without it.

  LENOVO U410 SOUND DRIVER

Linux and Hardware RAID: an administrator’s summary

You can find help regarding which commands are available from the command line utility by entering the ARCCONF command without additional commands or parameters.

Areca arcix raid card setup I was wondering why you we making so many mount points. I am using the raid card liunx setup 10 raid 1 arrays.

Find More Posts by lithos. BB code is On. Leave a Reply Cancel reply. If the command line utility has not been installed on the system, it can be raaid from the Thomas-Krenn. Find More Posts by ongte.