For more information, see Help and Support Center at http: I have other NIC, so it is not critical. Join the community here , it only takes a minute. Do you already have an account? Just checking ,but sometimes it is simple,Are there bios settings affecting the on board when another card is installed..
|Date Added:||6 March 2018|
|File Size:||8.15 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Do you already have an account?
Asus P4P Motherboard | eBay
The router is a netgear WGT For more information, see Help and Support Center at http: I already tried several other straight-through cables, all the same. Your name or email address: No conflicts are reported.
Add your comment to this article You need to be a member to leave lna comment. Your computer has automatically configured the IP address for the Network Card with network address xxxxxxxxxxxx. Last ditch the board you have warranty. TechSpot is dedicated to computer enthusiasts and power users.
Just checking ,but sometimes it is simple,Are there bios settings affecting the on board when another card is installed. The cable used is standard patch CAT-5e cable supplied with cable modem. I’ve had the router since November and all has worked fine before but the PC is brand new so it would be logical to assume asks is wrong with the NIC drivers but I’ve tried three revisions and no change.
Asus P4P800 Motherboards
Ask a question and give support. There are 2 computers on my network and they both have the same thing happening to them. Everything seems to be normal except that it will not go into “Connected” status. Azus, before the change took place everything went fine.
But for BaseT you will need a Cat-6 cable for it to work. They use more internal wires. I have other NIC, so it is not critical. However, what VCT reports makes no sense to me as it reports pairs and as connected correctly I’d expect and You must log in or sign up to reply here.
Sign up for freeit takes 30 seconds. No, create an account now. Join the community hereit only takes a minute. The Port A is down message indicates the router is power cycling, the NIC gets disconnected then picks up the connection when it’s back. After enabling it goes into “Network cable unplugged” state and stays there forewer.
Pick the controller “Configure” and the choose “Advanced” Tab.
Port A is down Data: Yes, my password is: Did you try a new cable they are easily screwed. TechSpot Account Sign up for freeit takes 30 seconds.
Anyone have a solution? In XP Event viewer there are following messages: Join thousands of tech enthusiasts and participate. As far as I know aeus should work for BaseT as well – especially when gigabit device is forced to behave as BaseT. The IP address being used is