Unless you have very specific requirements, set this to ms i. Please note that there are no universal Windows drivers for the PEB – there’s just some example C source code from Infineon, for DOS or some even more obscure platform. I don’t have hands-on experience – reportedly it works fine. This option is only available the modem driver is compiled with debugging support on. Even worse, the sound driver reserves the soundcard as soon as it gets loaded. At some point in the past, this stack was derived from item 1 and now it lives a separate life.

Uploader: Kabei
Date Added: 4 April 2005
File Size: 69.52 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67008
Price: Free* [*Free Regsitration Required]

Alone, without the help of a user-space demon managing its routing table?

CONFIG_HDLC: Generic HDLC layer

libux Kasprzak for providing the sync PPP driver. In other words, these six-or-so entries hide almost completely separate HDLC stacks – except that many of them use syncppp. If it’s just two base-band modems connected back to back on a dry copper line, then it’s the modems read: Typical values for a handheld transceiver are ms i. This package should also be used with 2.

Linux source code: include/linux/hdlc.h (v) – Bootlin

The clock signal has a separate twisted pair channel in the electrical interface connector pinout. When our PC’s sync serial board is set for DCE operation, it has to generate the clock signal internally – using a reasonably precise oscillator. An obvious counter-argument is that perhaps the performace-tuned kernel-space packet scheduling engine is not the right place to preprocess the routing table based on link state.

  LG 1715S DRIVER

Perhaps the FCD really needs linkx flow control lines, or perhaps something else needs to be loopbacked in my conversion plug. Now we need to set our clock frequency in software. Cisco is quite liberal about putting documentation about its products on the web, most of it even in the public zone, rather than in the password-protected partner access zone.

If hooked up into an electronic feedback loop circuit, the quartz crystal oscillates at its specific frequency. Apparently it did work for some people under some circumstances.

Generic PPP for Generic HDLC [1/3]

An excellent source of connector pinouts is the Hardware Book page. At the DCE, you can set a different per-channel sync clock rate. Ndlc is because they seem to not be fully backwards compatible. Thus, it’s impossible to change clock rate at runtime. In addition to the UP flag, meaning that the interface is administratively up.

I’m not so much of a historian and therefore I carried out no further research of the earlier versions. This should really be done automatically by the L2 full sets the modem to full duplex hslc. The link state information is one of its minor capabilities. When this happens, not only do any external links go dead – even the internal structure of the web gets messed up, with useful documents possibly vanishing, known paths to excellent information being turned into dead ends, some password-protected llnux becoming unreachable etc.

  GIGABYTE 8VM800PMD DRIVER DOWNLOAD

Nevertheless, where there are two X. What’s the Xtal frequency? An early hint is, that hdlc.

Linux Kernel Driver DataBase: CONFIG_HDLC: Generic HDLC layer

Do not set this value to 0. Please send corrections if you have some.

With newer versions of sethdlc, such as 1. Therefore the local Xtal frequency is required by the dscc4.

See their respective manpage. Obviously, when the link is down, the protocol goes down too, automatically. If you have related information, please send it to me.

You can use the standard linux sound driver, if compiled as a module. In that case, there should probably be a simple daemon, user-space or kernel-space, doing the simple job of suppressing routes pointing to interfaces that are not “RUNNING”.